Basic Rotary Sensors

This basic range of rotary sensors is available in different diameters and measures the angle of a target at up to 12mm gap. Used on end shaft, in conjunction with a CTU chip, the system reports full absolute angular position over 360°.

Normal Bold
1 / 3

Overview

This basic range of rotary sensors is available in different diameters and measures the angle of a target at up to 12mm gap.  Used on end shaft, in conjunction with a CTU chip, the system reports full absolute angular position over 360°.

The basic rotary sensor is a Type 1 sensor (find out more about how sensors are classified and what this means for CTU selection in our FAQ). A single CAM204 Central Tracking Unit (CTU) chip can operate up to 4 Type 1 sensors, including a mix of linear and rotary.

Basic rotary sensors are available in 25mm, 36mm and 50mm diameters.

Features

  • Simple non-contact target
  • Large gaps & misalignment
  • Full absolute sensing over 360°
  • Standard 4-layer PCB process
  • 25, 35 or 48mm diameter copper coil pattern
  • Highly repeatable

Performance

  • ±0.5° (±0.14%) Absolute Error at gap 1.5mm
  • ±1° at Radial Misalignment 1mm, gap 0.5…2.5mm
  • <±0.18° change (±0.05%) across temperature -40°C…85°C, ≤ 3.5mm Gap

Downloads

  • Datasheets Basic Rotary Sensor 25mm Datasheet PDF · 527 KB
  • Datasheets Basic Rotary Sensor 36mm Datasheet PDF · 296 KB
  • Datasheets Basic Rotary Sensor – 50mm Datasheet PDF · 350 KB
View all resources

Registered users get access to the full download library, including CTU Software and sensor blueprints.

Order

Basic Rotary Sensors

Buy Now

Related products for Basic Rotary Sensors

All products

CAM312

The CAM312 is a cost effective processor IC for resonant inductive position sensing. It can connect to and process up to two sensors, and reports results over an SPI interface.

Read more CAM312

CAM312 Development Board

CAM312 Development Board includes a CAM312 chip and the external circuitry required for operating up to two Type 4 sensors, or one Type 2 or Type 6 sensor.

Read more CAM312 Development Board

Connecting Cables

A selection of cable assemblies is available for connecting between assembled sensors and development boards, and for connecting to their SPI interface connector.

Read more Connecting Cables

Solutions for Innovators

Register to download software tools or get advice directly from CambridgeIC’s engineers